KFX 450 HQ Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 · (Edited)
Roll over sensor is basically resistor voltage divider with Hall effect switch. Magnet is mounted on a small plastic pendulum. When magnet is positioned over the switch, switch turns on, effectively shorting out 15K resistor and that results in 0.6V on the middle pin.

If your roll over sensor is busted, while you are waiting on a new one to replace it, you can short out 15K resistor with a piece of wire to emulate correct operation. In my case I removed IC and replaced 15K with O ohm resistor in the pics below.

Some soldering required.... Here are a few pics:
Rectangle Slope Font Plot Parallel
Passive circuit component Circuit component Hardware programmer Electronic engineering Technology

Circuit component Passive circuit component Hardware programmer Electronic component Electronic engineering

Circuit component Water Passive circuit component Electronic component Engineering


Disclaimer: do this mod on your own risk. Author cannot be held responsible/liable for any issues related to this mod.
 
1 - 1 of 1 Posts
Top