KFX 450 HQ Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
190 Posts
Discussion Starter #1
Ok so I took off the upper and lower a arms first and then tapped out the ball joints for the a arms attached to the wheel. Then I removed the brake lines and I had a wheel with the spinning thing inside it which still attached to the ti rod ball joint. I can't figure out how ti get it out because the wheel is in the way. I there anyway to get it out without removing the wheel? If so, how?
 

·
Registered
Joined
·
190 Posts
Discussion Starter #3
That is exactly what I need but is there any other way?
 

·
Registered
Joined
·
3,851 Posts
Just tap the spindle with a hammer around the ball joint area and pull up on the ball joint while hammering and it will pop out.
 

·
Registered
Joined
·
3,612 Posts
+1 but you may have to do more than tap it. It usually takes a pretty good hit to get it to pop out.
 
1 - 5 of 5 Posts
Top