KFX 450 HQ Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
hello,

I was replacing front brake pads on the kfx450 I recently purchased used and one of the holes on the right caliper holder has stripped threads.

I see caliper holder is available on-line, PN#43044A.

How hard is it to replace it? Parts diagram does not show any bolts, only rubber boots. Here is part I am talking about circled and stripped hole with arrow pointing at it:
White Font Line Parallel Technology
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #2 ·
Ok, I bought used set of calipers and swap was easy. I simply pulled caliper holder off, greased it up with 3M silicon grease, slipped boots on and pushed holder in place. All in all, 10 minutes.
 
1 - 2 of 2 Posts
Top