[joeraptor2003]

Hello all
I am hoping someone can chime in here and help me .Very frustrated. I did self diagnostic thing. Got error code 2 long and 1 short . Looked it up and says that it means the crank sensor sensor is bad. I went and bought a whole new stator which you have to buy because the sensor is attached to the stator. Put in the new stator. Go to try and start and again getting same message. So far I have replaced the starter relay and roll over sensor ..now the stator... I'm at my Witt's end with this quad. Anyone else have an idea? Why would it keep giving same message even after replacing the sensor?
Please help!

 

[joeraptor2003]

Anyone ever run into this same issue? Thanks

 

[Dust Devil]

Anyone ever run into this same issue? Thanks

It could be the harness connection to the crank sensor or the main ECU connector ..Check for damage & clean from dirt/debris & moister, to see if it clears

 

[joeraptor2003]

Thanks for the helpful advice.
Well I pulled the wiring harness off and couldn't find any obvious breaks anywhere. I am going to order a new Wire harness soon. Keep you guys posted> Man I hope this works..

 

[Superhik]

Did it work?