KFX 450 HQ Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
41 Posts
Discussion Starter #1
My Drw case saver came in yesterday. I tried installing it, but had trouble getting it mounted. I dont know if it's common to have to trim some off if these or what, but the screw for the lower mounting hole wasn't long enough to reach the threads in the case. I sent them a message but still waiting to hear back.
 

·
Registered
Joined
·
41 Posts
Discussion Starter #3
I got it figured out. The mounting holes were just slightly off center. I ended up taking a drill but slightly larger than the mounting holes and drilling them out. After this I was able to get it mounted just fine.
 

·
Registered
Joined
·
41 Posts
Discussion Starter #4
I talked to the guy at Drw (forgot his name), he said he tries to make his tolerances very tight, and that one must have just been drilled a tiny bit off. Making the holes a tiny bit larger in diameter took care of it. I'm happy overall now, hopefully I never have to find out if the case saver does its job.
 
1 - 4 of 4 Posts
Top